The most common problem with the CerMark process is when incorrect laser settings are used and the material does not create a permanent bond to the item.
This is normally due to laser power being too low and or speed settings being too fast. It can result from the laser not being in focus or the laser optics may require cleaning or replacement.
No two CO2 laser tubes put out the exact same amount of energy so we can not create specific settings charts. You will have to do testing to determine specific power and speed settings for each of your own systems.
Every material types require different power and speed settings. Hard metals like stainless steel can be marked at much faster speeds then softer metals like aluminum and copper which suck the laser heat away quickly.
Many times brass and copper items will have a clear coating on them to prevent tarnish. These coatings prevent CerMark from bonding to the base metal.
Thicker application of CerMark does not make a darker mark or make it stick better. For best mark results spray application of CerMark with just enough coating to hide the base material. In the case of glass marking you want to be sure you can not see through the CerMark coating.
Below are a documents related to the proper use of CerMark laser marking materials. Further support documents are being added to this webpage on a regular basis.
CerMark Sales is a distributor of CerMark laser marking material that are manufactured by Ferro Corporation. CerMark Sales is owned and operated by Advanced Identification, Inc.
You can purchase CerMark products with no minimums by following this link.
For CerMark telephone support dial 866-241-9881 ext. 242